Step 1. Lay one unfolded piece of 4×4 gauze on the emesis basin.

Step 2. Fold 1-2 cm of the foam tape over itself to create the edge of the fascia.

Step 3. Arrange 2 pieces of folded foam tape over the gauze, leaving a small space between the 2 pieces.

Step 4. Color the edge of the fascia, and the gauze at the base of the wound with the red magic marker.

Step 5. Cut the 2 inch ace wrap longitudinally. Arrange the free edge of the ace wrap along the wound edge. This will form the sub-cuticular structures, and prevent the skin layer from adhering to the fascial layer.

Step 6. Place a layer of white foam tape along each side of the wound. This will be the skin layer. The edges of the wound can be secured with tape to prevent them from lifting off the base. In the end, the layers from deep to superficial are: gauze, folded foam tape, ace wrap, and single layer of foam tape.

Step 7. For added realism, paint the skin layer with Betadine, and apply a fenestrated drape.

When the model is assembled on the bottom of a 7 quart emesis basin it provides approximately 20 cm of ‘wound’ to suture.